The dog house heater glossary
GFCI, PTC, IPX4, MET listed: dog house heater listings speak their own language. This page explains the 30 terms you will meet most often, each in a few sentences and backed by the numbers of the heaters and pads in our lineup.
These are the words that keep turning up on dog house heater listings and in the advice around them, sorted alphabetically. Each entry points to the guide that goes deeper.
The figures come from the six heaters and pads in our dog house heater comparison. You can see them side by side in the comparison table on the homepage.
A
- Automatic shut-off
- Any feature that cuts the heat without you touching a switch, either because the house is warm enough or because something is too hot. The Briidea 400W stops heating at the temperature you set and runs its fan five more minutes, while the Dreyoo’s element stops above 78.8 °F. It is a backstop, not a reason to skip the setup in our dog house heater safety rules.
C
- Chew guard
- A metal or hard plastic conduit that sleeves a power cord where a dog could reach it. Even a steel-wrapped cord benefits from one along the run between the house and the outlet. How to route and protect the cord is shown in our guide to installing a dog house heater.
- Cubic feet
- The volume of air inside the house, which is how most heater makers rate coverage. Multiply length, width and height in inches and divide by 1,728, so a house measuring 36 × 30 × 30 in inside comes to about 19 cubic feet. Heaters rated for 100 to 150 cubic feet have plenty of margin, as our guide to sizing a dog house heater explains.
D
- Door flap
- A heavy plastic or rubber curtain over the doorway that the dog pushes through. It stops wind from blowing straight in and holds warm air inside, which helps any heater do its job. Face the door away from the prevailing wind too, as our guide to insulating a dog house describes.
- Dual wattage
- A heater with two power settings, so you can trade heat for running cost. The Dreyoo switches between 300 W and 600 W, and the TURBRO Neighborhood between 400 W and 800 W. The lower setting is often enough in an insulated house, and our guide to running costs shows what each setting uses.
F
- Fan heater
- A heater that blows air across a hot element and into the house. Four of our six work this way, from the Akoma Hound Heater Deluxe with its quiet fan to the Dreyoo, Briidea and TURBRO models. Fans pull in hair, so hair guards and mesh vents matter; how a fan heater compares with a pad is in wall heater or heated pad.
- Frostbite
- Frozen tissue, most often on the ears, tail tip and paw pads, where blood flow is thinnest. General veterinary guidance puts every dog at risk outdoors below about 20 °F, and wind or wet fur makes it worse. Signs and thresholds are in our guide to how cold is too cold; see a vet if you suspect it.
G
- GFCI
- A ground-fault circuit interrupter, the outlet or breaker that trips in a split second when current escapes to ground, through water or a body. The National Electrical Code requires GFCI protection for outdoor receptacles. Plug every dog house heater into one, as our guide to outdoor power and cords explains.
H
- Heat lamp
- An incandescent or infrared bulb in a reflector, sold for barns and coops. Near straw, wood shavings or fur, heat lamps are a well-known source of barn and coop fires, and the bulbs can shatter. They are not built for an enclosed dog house, which is why we explain why a heat lamp is the wrong choice.
- Heat shield
- An internal barrier that keeps the hot element away from wires and outer parts. Akoma lists one inside the Hound Heater Deluxe, along with rounded corners. Our Hound Heater Deluxe review covers the rest of its safety design.
- Heated pad
- A low-wattage pad that warms the dog lying on it rather than the air around it. The K&H Lectro-Kennel is rigid ABS plastic, draws 60 W in the Medium by K&H data and warms its surface to about 100 °F in use. Our top pick, the soft 40 W K&H Lectro-Soft bed, works the same way for dogs that do not chew. A pad should leave some bare floor beside it for the dog to move onto, as our Hound Heater and Lectro-Kennel duel discusses.
- Hypothermia
- A body temperature that has dropped too low. In dogs the signs are shivering, lethargy and weakness, and small, short-coated, young, old or sick dogs are at risk first. Bring the dog inside and call a vet; the thresholds by temperature are in our guide to cold limits.
I
- Insulation
- Material in the walls, roof and floor that slows heat leaking out. An insulated house holds the dog’s own body heat, lets a heater cycle off more often and cuts the running cost. Do this before you add heat, as our guide to insulating the dog house first argues.
- IPX4
- An ingress protection rating meaning the device resists splashing water from any direction. The TURBRO Neighborhood’s controller carries it, because it mounts outside the house where rain and snow reach it. It does not make a plug or connection waterproof, so keep those off the ground as our outdoor power guide describes.
K
- kWh
- A kilowatt-hour, the unit your electricity bill counts. Watts times hours divided by 1,000 gives kWh, so a day of nonstop running comes to 9.6 kWh for a 400 W heater and 1.44 kWh for a 60 W pad. A thermostat cuts the real figure, as our guide to what a heater costs to run works out.
M
- MET listing
- Certification by MET Laboratories, one of the nationally recognized testing laboratories accredited under OSHA’s program, much like UL. Retailers describe the K&H Lectro-Kennel as MET listed, and K&H says it certifies the whole product. What to look for on any label is covered in our look at dog house heater brands.
- Mylar
- A thin reflective polyester film, the material of the space blanket. In a self-warming pet bed it bounces the dog’s own body heat back without any electricity. It suits mild cold and houses with no outlet, as the guide to ways to keep a dog house warm without power shows.
O
- Outdoor extension cord
- A cord rated for outdoor use, marked with a “W” on the jacket, in a gauge heavy enough for the heater’s watts. Keep it as short as possible, plug it in once and never daisy-chain cords. The full rules are in our guide to safe outdoor power.
- Overheat protection
- A cut-out that switches the element off if the heater itself gets too hot, for example when the vent is blocked. The Dreyoo and the TURBRO Neighborhood both list it. It does not replace keeping bedding clear of the heater, one of our nine safety rules.
P
- PTC element
- A positive temperature coefficient heating element, usually ceramic, whose resistance rises as it warms, so it limits its own temperature. The Dreyoo 600/300W and the Briidea 400W both use one. Self-limiting does not mean cool to the touch, so mount it high as our guide to installing a heater shows.
R
- R-value
- A measure of how well a material resists heat flow; the higher the number, the better it insulates. Rigid foam board scores well for its thickness, while bare plywood scores poorly. Which materials fit a dog house is in our guide to dog house insulation.
- Raised floor
- A floor lifted a few inches off the ground on legs or blocks. The Humane Society advises it, because cold and damp rise from the ground and a gap underneath stops them. It also keeps a heated pad and its cord out of standing water, as our heater or pad guide notes.
S
- Self-warming bed
- A pet bed with a reflective layer, often Mylar, that returns the dog’s own warmth and needs no power. It costs nothing to run and has no cord to chew. It helps in mild cold but is no heater, as our guide to warmth without electricity explains.
- Steel-wrapped cord
- A power cord sheathed in a coiled steel spring that resists teeth. The K&H Lectro-Kennel and Lectro-Soft have one, the Lectro-Soft’s 5.5 ft long, and the Dreyoo’s 6 ft anti-bite cord is steel-wrapped too. Our guide to a cheap dog house heater shows why it matters on budget models.
- Straw
- The hollow dry stalks of grain plants, the bedding the Humane Society recommends for outdoor dogs. Straw stays dry and traps air, while blankets and hay hold moisture. Keep it well clear of any heater, as our safety guide explains.
T
- Thermostat
- A control that switches heat on and off to hold a temperature. The Hound Heater has a knob on top, the Briidea a range from 32 to 122 °F and the Dreyoo a fixed window from 68 to 78.8 °F. Heated pads have one too, which brings the Lectro-Kennel to about 100 °F in use; see how much heat a dog house needs.
U
- UL listing
- Certification by UL, the best-known safety testing laboratory in the US. Read the wording closely, since the Dreyoo listing claims UL certification, Briidea says its cord is UL certified, and TURBRO says the heater passed a UL test. We could not confirm anything independent beyond those claims, as our look at heater brands explains.
W
- Wall mount
- Fixing a heater high on an inside wall, out of nose and paw reach. The Hound Heater fixes with four screws or bolts on a side wall, with a separate bracket for igloo-style houses, while the Dreyoo uses a bracket. The steps are in our guide to mounting a dog house heater.
- Watt
- The unit of electrical power, and the number that tells you how much heat a heater can make. Our six run from 40 W on the Lectro-Soft to 800 W on the TURBRO’s high setting. How many your house needs is the subject of our guide to heater watts and house size.
- Wi-Fi control
- A heater you watch and adjust from a phone app. The TURBRO Neighborhood pairs with the AIR.ai app, which shows the temperature and lets you set timers and the target from afar, and Akoma sells a pricier Wi-Fi version of the Hound Heater. An app is useful, yet it cannot stand in for a daily check on the dog; our TURBRO Neighborhood review weighs it up.