Our top pick
K&H Lectro-Soft outdoor heated bed
The Lectro-Soft is a soft orthopedic foam bed with a 40 W heater inside. It lies on the floor of the dog house and warms the dog curled up on it, so the heat goes where the dog sleeps.
Its thermostat brings the surface toward your dog’s normal body temperature, and only while the dog is lying on it. An empty bed may not feel warm to your hand, and that is how K&H designed it.
Even if it never switched off, 40 W adds up to about 0.96 kWh a day, roughly 14 cents at an example rate of 15 cents per kWh. There is nothing to mount, and Amazon sells and ships it.
- Power
- 40 W, thermostat-run
- Warms
- Toward body temperature, in use only
- Size
- 24 × 19 × 2 in (Medium)
- Cord
- 5.5 ft, steel-wrapped
- Cover
- Washable fleece, waterproof bed
- Safety
- Safety listed (K&H)
- Setup
- No drilling, lies on the floor
- Weight
- 2.74 lb
The first evening, step by step
A bed has no wall to drill, but the floor and the cord still decide how safe it is. This order gets both right before your dog lies down.
Before it goes in the house
- Check that the outdoor outlet is GFCI-protected and works
- Dry the floor, and raise it off the ground if you can
- Measure the floor so bare floor or straw stays beside the bed
- Plan the cord route out a small hole in the back wall, inside a hard chew guard
- Use an outdoor-rated extension cord only if you must, and only one
Then lay it down, unplugged
Once it is in
- Set the bed at the back, away from the door and the wind
- Plug it in and let your dog find it, with a worn shirt on top the first night
- Feel under the cover after the dog has lain there a while
- Keep the cord connection off the ground and out of snow
- Look at the dog, the cover and the cord every day
What it has, and what it lacks
What it has
- Warmth right under the dog for only 40 W
- A thermostat that warms only while the dog lies on it
- No drilling, no bracket and no wall needed
- Soft orthopedic foam and a washable fleece cover
- A steel-wrapped cord and the most owner reviews of the six
What it lacks
- Any use for a dog that chews, per K&H
- Warm air, since it heats the dog and not the house
- Enough heat on its own below about 20 °F
- A long cord, at 5.5 ft the shortest here
Between us, before you order
K&H says the Lectro-Soft is not recommended for pets that chew. If your dog has ever torn up a cushion, take the rigid Lectro-Kennel pad or a wall heater mounted out of reach instead.
It is meant for sheltered spots, such as the inside of a dry dog house, a shed, a garage or a barn. Fix drafts, hang a door flap and raise the floor first, and the bed’s warmth stays with the dog.
When nights fall below about 20 °F, the bed cannot do the job alone. Bring your dog inside, or add a wall heater and insulation, and keep fresh unfrozen water and enough food on hand.
What owners report
The Lectro-Soft has more owner reviews on Amazon.com than any other product in our lineup. We collected no recurring themes beyond that, so we won’t invent any.
What we can add comes from K&H and the listing. Amazon sells and ships it and it is returnable, and K&H names sheds, garages, barns and sheltered areas as its place.
Buy it if
Your dog is calm, leaves its bedding alone and sleeps in a dry, sheltered dog house, and you want steady warmth under it with nothing to install and almost nothing on the bill.
Skip it if
- Dog chews? Take the rigid Lectro-Kennel pad
- Big or drafty house? Warm the air with the Hound Heater
- Nights below 20 °F? Read how cold is too cold first
- No outlet nearby? Read the no-power options first
Ready for a warm dog bed all winter?
Plan for a GFCI outlet, a chew guard for the cord and a dry floor. Do that for a calm dog that leaves its bedding alone, and the Lectro-Soft is the warmth we would trust in our own dog’s house.