Nine dog house heater safety rules
A heater in a dog house puts electricity and heat a few feet from straw and a curious mouth. These nine rules cover fire and chewing, and they apply to every wall heater and heated pad we compare.
Why a dog house needs its own rules
A dog house is small and full of bedding that burns. The dog living in it is alone for hours at a stretch and may treat any cord as a chew toy.
None of the rules below is hard to follow. Each one closes a way a setup can go wrong, so run through all nine before the first cold night and again whenever something changes.
The nine rules
1. Mount the heater high and out of reach
A wall heater belongs high on a side wall, above your dog’s nose and paws when it stands or rears up. Dreyoo’s listing says to mount its heater higher than the pet, and every maker gives its own clearance instructions.
Out of reach means the dog can’t lick the grille or lean against the casing. Our installation guide shows where to place the heater and how to fix it firmly.
2. Protect every inch of the cord
A chewed cord is the most direct way a dog gets hurt by a heater. Choose a heater or pad with a chew-resistant or steel-wrapped cord, such as the Hound Heater’s heavy-duty chew-proof cord or the Lectro-Kennel’s steel wrap.
Then cover the run from the house to the outlet with a metal or hard conduit, so no loop hangs within reach. Route it out the back of the house, away from the door.
3. Plug into a GFCI outdoor outlet
The National Electrical Code requires outdoor receptacles to have GFCI protection. A GFCI cuts the power in a fraction of a second when current leaks to ground, through water or a chewed wire.
Press the test button on the outlet before winter starts. If it doesn’t trip and reset, have the outlet fixed before the heater goes in.
4. Use one outdoor-rated cord, as short as possible
If the outlet is not right next to the house, use a single outdoor extension cord marked “W”, of the right gauge for the heater’s watts. Plug it in once, with no daisy-chaining of cords or power strips.
Keep the connection off the ground and out of snow, ideally inside a weatherproof cover. Our guide to safe outdoor power and cords explains gauges and covers.
5. Keep bedding clear of the heater
Straw is the right bedding outdoors, because it stays drier than blankets or hay, according to the Humane Society of the United States. It also burns, so keep it away from the heater’s grille and air outlet.
Check after the dog has been in, since dogs dig and push bedding around. Fur builds up on vents too, which is why several heaters here have a hair guard or filter you can remove and clean.
6. Never use a heat lamp, a flame or a room heater
Heat lamps near straw or wood shavings are a well-known fire cause in barns and coops, and their bulbs can shatter. Our guide on why a heat lamp is the wrong dog house heater goes into the details.
Propane and kerosene heaters, candles and anything else with a flame are out of the question, because of fire and carbon monoxide. So is an indoor space heater, which is not built for an enclosed box full of bedding.
7. Choose a thermostat and overheat protection
A thermostat stops the heater from running nonstop, and overheat protection cuts the element if something goes wrong. Dreyoo, Briidea and TURBRO all list temperature or overheat protection, and the Hound Heater has an internal heat shield over its wires and parts.
Read certification claims carefully. Dreyoo’s listing claims UL certification and TURBRO’s says it passed a UL test, but we found no independent confirmation for either.
8. Leave room to move off a heated pad
A pad must cover only part of the floor, so your dog can step off when it gets too warm. A dog that can’t get away from the heat may overheat, above all a puppy or an old dog.
Match the pad to the dog. K&H does not recommend the soft Lectro-Soft bed for pets that chew, while a rigid pad like the Lectro-Kennel resists chewing better.
9. Check on your dog every day
Look at the heater, the cord and the bedding daily, and feel whether the house is warm or stuffy. Watch the dog too, because shivering or unusual lethargy can signal hypothermia and needs a vet.
A heater never replaces bringing your dog inside when the cold turns dangerous. Fresh water that has not frozen and enough food matter as much as the heat.
The nine rules in one table
| Rule | What to check |
|---|---|
| 1. Height | Heater above nose and paw reach |
| 2. Cord | Chew-resistant cord inside a conduit |
| 3. Outlet | GFCI trips and resets |
| 4. Extension | One outdoor “W” cord, connection off the ground |
| 5. Bedding | Straw clear of grille and outlet |
| 6. Heat source | No heat lamp, flame or indoor heater |
| 7. Controls | Thermostat and overheat protection work |
| 8. Pad space | Bare floor beside the pad |
| 9. Daily check | Dog, water, food and setup |
Products that make the rules easier
A heater with a tough cord and a heat shield takes care of rules two and seven out of the box. That is why the Hound Heater is our best wall heater, and the homepage list of things to sort before you buy adds more.
If you are still choosing between warm air and a warm floor, our guide to wall heaters and heated pads covers the safety side of each. For the shortlist, see the safest dog house heaters we would use ourselves.
Built with chewing and fire in mind
Akoma gives the Hound Heater Deluxe a heavy-duty chew-proof cord, an internal heat shield and rounded corners, and rates it for 100,000 on/off cycles. You still need a GFCI outlet and a daily check, because no heater makes those rules optional.